Filter
Top Products
−
17
−
BATT
EXT.
MAIN SW
③
Connect the input power plugs of the load devices to the output terminals.
Output terminal capacity
Note
125V 15A
terminal
×
6
If you must make a single-wire
grounded connection, always
connect the ground phase to the
V terminal (phase) side.
Note
The total output from all output terminals must not exceed 10A.
7.2 External Interface Connections
Connect a computer or option card as required.
For details, see §5.3 “External Interfaces” and §10 “User Settings”.
Note
The CARD I/F and PC I/F connectors cannot be used at the same time.
7.2.1 Connections to the PC Interface (PC I/F)
Connect a computer to the PC I/F connector to control the UPS by using the supplied power
management software.
Install the power management software on the computer, and connect the computer to the
UPS with the supplied network cable. For more information, refer to the Install Guide or User
Guide in the CD-ROM of the power management software.
Before making the connection, check that item
⑤
“PC Interface mode” in §10.1 “Setup Menu
Item List” is set as follows.
Interface mode: Workstation mode
7.2.2 Connections to the Card Interface (CARD I/F)
Connected an optional LAN interface card.
Before making the connection, check that item
⑤
“PC Interface mode” in §10.1 “Setup Menu
Item List” is set as follows
.
Interface mode: Workstation mode
Note
This connector is for use with Sanyo option cards only. Contact your supplier for more
information about option cards.
Terminal rated capacity
A
C125V 15A
The total load connected to the 6 output
terminals must not exceed 10A.
U
V
E