Sanyo E11A202U Power Supply User Manual


 
11
5.3 External Interfaces
UPS back panel
No.
Name
Function
PC I/F
(PC interface)
(RS-232C)
Allows you to control the UPS from a computer (PC or workstation) by using the
supplied power management software. Install the power management software (*2)
on the computer, and connect the computer to the UPS with the supplied network
cable.
Interface mode (*1): Workstation mode
(*1): Use the controls on the front panel to set the interface mode. For more
information, see item
PC Interface mode in §10.1 “Setup Menu Item List”.
(*2): For more information, refer to the User Guide in the CD-ROM of the
SANUPS SOFTWARE.
CARD I/F
(Card interface)
Allows you to connect an optional Sanyo LAN interface card.
Interface mode (*1): Workstation mode
Note
This connector is for use with Sanyo option cards only.
Note
The CARD I/F and PC I/F connectors cannot be used at the same time.
2
RXD (in)
3
TXD (out)
5
(COM)
1
7V,1A/Option powe
r
Cannotbe
used with
other than
Sanyo
option cards.
2
RXD
3
TXD
5
GND
4
DTR
6
DSR
8
CTS
7
RTS
D-sub9-pin (male)
Fixing screw
inch
D-sub
9-pin (male)
Fixing screw
inch
(Femal
e
)