Filter
Top Products
51
Setting
Ceiling
Rear
Ceiling
When this function is set to “On,” the picture will be
top/bottom and left/right reversed. This function is used to
project the image from a ceiling-mounted projector.
Rear
When this function is set to “On,” the picture will be
left/right reversed. This function is used to project the
image from rear of the screen.
Input search
This function detects the input signal automatically. When a
signal is found, the search will stop. Use the Point 7 8
buttons to select one of the following options.
Off.......... Input search will not work.
On1 ........ Input search works under the following situation.
–When pressing the INPUT button on the top
control.
– When pressing the COMPUTER button or
VIDEO button on the remote control.
On2 ........ Input search works under the following situation.
–When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the COMPUTER button or
VIDEO button on the remote control.
–When pressing the INPUT button on the top
control.
–When the current input signal is cut off.*
*If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
✔Notes:
•While Input search is set to “On1” or “On2,” the status of Input and Lamp are displayed every time the signal is switched.
•Only the last selected input source can be detected.
•If the INPUT button on the top control or COMPUTER or VIDEO buttons on the remote control is pressed during Input search is
in progress, Input search will stop and go back to the previous input signal.