Filter
Top Products
68
Appendix
Some displays are not seen – Check the Display function. See page 48.
during the operation.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up. you have set). See pages 22, 54–55.
The Remote Control does – Check the batteries.
not work. –Make sure no obstruction is between the projector and remote
control.
–Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4’ (5 m).
–Make sure the code of the remote control is conformed to the
projector’s code. See page 53.
– Unlock the Key lock function for the remote control function. See
page 54.
–Make sure “ALL-OFF” switch on the remote control is set to “ON.”
See page 13.
Alarm does not stop ringing. – Connect the AC power cord to the AC outlet. (Alarm will not stop
ringing when the alarm goes off while trying to remove the
rechargeable battery cover.)
Warning mode is not turned on. – If you cannot hear the bleeping sound when you press the Alarm
buttons, you are not pressing the buttons correctly. Try to set the
Alarm setting again.
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.
Pixelworks ICs used.