Filter
Top Products
46
Setting
On start
When this function is “On”, the projector is automatically
turned on just by connecting the AC power cord to an
outlet.
✔
Note:
• Be sure to turn the projector off properly (see “Turning Off the
Projector” on p. 20). If the projector is turned off in the incorrect
sequence, the On start function does not operate properly.
Lamp control
Remote control
This projector provides two different remote control codes;
the factory-set, initial code (Code 1) and the secondary code
(Code 2). This switching function prevents remote control
interference when operating several projectors or video
equipment at the same time.
When operating the projector in “Code 2”, both the
projector and the remote control must be switched to
“Code 2”.
To change the code for the projector;
Select either “Code 1” or “Code 2” in this Setting Menu.
To change the code for the remote control;
Press and hold both the MENU and IMAGE buttons
together for 10 seconds or more. After changing the code,
make sure the remote control operates properly.
Remote control
Press and hold
MENU and
IMAGE buttons
for 10 seconds or
more.
You can change the brightness of the screen.
Normal ....Normal brightness
Auto ........Brightness according with the input signal
Eco ..........Lower brightness reduces the lamp power
consumption and extends the
lamp life.
On start
✔
Note:
• When different codes are set on the projector and on the remote
control, any operation cannot be made. In that case, switch the
code on the remote control to fit the code on the projector.
• When the batteries of the remote control are replaced, the remote
control code automatically returns to the initial code (Code 1).