Filter
Top Products
59
Appendix
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Some displays are not seen –Check the Display function. (See p. 42)
during the operation.
PIN code dialog box appears at start-up. –PIN code lock is being set. Enter a PIN code (1234 or
numbers you have set). (See p. 19, 47, 48)
Computer 2 cannot be selected. –Select Computer 2 at the Terminal function. (See p. 45)
The Terminal function cannot be selected. –The Terminal function cannot be selected after Computer 2 is
selected. Select other input source such as Computer 1 or
Video with the COMPUTER button or the VIDEO button on
the remote control so that the Terminal function can be
selected.
The Remote Control does not work. –Check the batteries.
–Make sure no obstruction is between the projector and the
remote control.
–Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4’ (5m).
–Make sure the code of the remote control is conformed to
the projector. (See p. 46)
Cooling fans are still running after –This is normal condition. Fans keep running for a certain time
the AC plug is disconnected. even after disconnecting the AC plug.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist
after following all operating instructions,
contact the dealer where you purchased the
projector or the service center.
Give the model number and explain about the problem. We will advise you
how to obtain service.
Pixelworks ICs used.
Appendix