Filter
Top Products
14
Installation
HDMI 1
COMPUTER
CO
CO
S-VIDEO
HDMI 2
VIDEO
Pb/CbYPr/Cr
This projector uses nominal input voltages of 100 – 120 V or 200 –
240 V AC and it automatically selects a correct input voltage. It is
designed to work with the single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service station.
Connect the projector with all peripheral equipment before turning
it on.
CAUTION
For safety, unplug the AC power cord when the projector is not
in use.
When the projector is connected to an outlet with the AC power
cord and the Main On/Off switch is on, it is in stand-by mode
and consumes a little electric power. Turn the Main On/Off
switch off when the projector is not in use.
Connecting the AC Power Cord
Connect the AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and must
be easily accessible.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and a proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
To power cord
connector on your
projector.
Projector side AC outlet side
Ground
To the AC outlet.
(120V AC)
For Continental EuropeFor the U.S.A. and Canada For the U.K.
To the AC outlet.
(200 – 240V AC)
To the AC outlet.
(200 – 240V AC)