Filter
Top Products
40
Setting
This function resets the lamp replacement counter. When replacing
the projection lamp, reset the lamp replacement counter with this
function. See page 48 for operation.
Lamp counter reset
Factory default
This function restores all setting values except for the user’s logo
and the lamp counter to the factory default settings.
Select [Yes] and press the
OK button, then another
confirmation box appears.
Factory default
Panel adjustment
This function is used to get the best picture reproduction of the R
(red), G (green), and B (blue) LCD panels. If the proper adjustment
is not made, you might get vertical noise lines on the screen.
This function should be made more than 10 minutes after turning
on the projector with or without any signal.
A dark environment helps make more accurate adjustment.
Press the OK button or Point
8 button and the Test pattern
screens will appear in the order of R (red), G (green), and B (blue).
Use the Point
ed7 8 buttons to adjust each pattern as follows:
1. Adjust the value in the Bright dialog box to minimize vertical
lines in the bright part of the picture.
2. Adjust the value in the Dark dialog box to minimize vertical
lines in the dark part of the picture.
3. Press the Point
ed buttons to move on to the next color.
Repeat step 1 and 2 for each R,G,B panel until the vertical
lines of the picture are minimized.
4. Press the Point
ed buttons to display the Check pattern
screen and check the adjustment.
5. To close this screen and return to the menu, press the OK or
MENU button.
1.Adjust the bright parts with the Bright dialog box.
3.Then adjust the Test pattern G and
Test pattern B in the same way.
2.Adjust the dark parts with the Dark dialog box.
4.Check the adjustment with Check pattern screen.
Select Factory default and
press the OK or Point
8
buttons. “Return to Factory
default?” appears.
Select [Yes] again to
restore to the factory
default settings.
When using the projector in high altitudes (about 1,200 meters or
more above the sea level), set this function “On.” Press the Point
8 or OK buttons to switch On/Off.
Highland
Cleaning
This function is used to clean the inside of the projector. Using a
blower as well is more effective. See page 44.
Press the Point
8 or OK buttons, then the projected image is
blacked out temporarily regardless of whether or not an input
source is selected. The fans start to operate automatically to help
blowing the dust.
To cancel the cleaning function, set the projector back into the
right position, then press any other button during cleaning
operations.
✔Note:
• The Power management function cannot be operated during cleaning.