Filter
Top Products
26
Select the installation mode according to the situation in which the projector is installed.
When using in the broadcast mode, it is necessary to set up the ID number into the receiver
which is conformed to that of the transmitter.
Setup them side by side as described below.
Main Menu 6/6: Mode Select
1. Press the MENU button to show the Menu. Press the Point
de
buttons to select Main
Menu 6/6: Mode Select and then press the SELECT button.
2. Press the Point
7 8
buttons to select the Broadcast Mode. The LINK indicator lights
orange.
3. Input signal will be displayed [B] in the lower left-hand corner.
Main Menu 4/6: ID Number
1. Press the MENU button to show the Menu. Press the Point
de
buttons to select Main
Menu 4/6: ID Number and then press the SELECT button.
2. An eight-digit
ID Number will be displayed. Note it and set up the same ID number in
the projector.
3. Press the MENU button to exit this Menu.
Broadcast Mode Operation
TRANSMITTER
Single
Mode
Mode 6/6
Select
Broadcast
Mode
ID Number 4/6
ID Number
****-****
6/6: Mode Select & 4/6: ID Number
✐ When selecting "INPUT 3 HDMI" in Single Mode, Broadcast Mode cannot be selected..
✐ ID Number characters : 0 to 9, A to F
INPUT SIGNAL >>
<none>
Link On
RF Freq. **.*MHz
Authentication
[Yes] NO
Authentication
Yes [NO]
Authenti- 1/2
cation
Transmission
[OK] NG
Phase 1/2
INPUT SIGNAL >>
[S] <none>
Input Lock Key
[#]### OK
Input Lock Key
#[#]## OK
Input Lock Key
##[#]# OK
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
Wireless 2/5
Setup
Wireless 3/5
Initial Setup
Information 4/5
Key Lock 5/5
Key Lock 5/5
Video 1/5
Setup
Hello
HD Data Wireless
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
H Freq.
V Freq.
H Rez. ****
V Rez. ****
Initialize 2/2 Initialize
[YES] NO
Initialize
YES [NO]
Transmission
OK [NG]
H Position 2/2
INPUT SIGNAL >>
[S] XGA 1
Input Lock Key
###[#] OK
Input Lock Key
#### [OK]
INPUT SIGNAL >>
[B] XGA 1
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>