SATO CX200 Label Maker User Manual


 
SATO America, Inc.
10350-A Nations Ford Rd.
Charlotte, NC 28273
MainPhone: (704) 644-1650
TechnicalSupportHotLine: (704) 644-1660
Fax:(704) 644-1661
http://www.satoamerica.com
© Copyright 1998
SATO America, Inc.
Warning: This equipment has been tested and found to comply with the lim-
its for a Class B computing device pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed in accordance with
the instruction may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try and correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet or a circuit different from that
to which the receiver is connected.
Consult an experienced radio/TV technician for help.
Caution: The FCC warns the users that changes or modifications of the unit
not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
All rights reserved. No part of this document may be reproduced or issued
to third parties in any form whatsoever without the express permission of
SATO America, Inc. The material in this document is provided for general
information and is subject to change without notice. SATO America, Inc. as-
sumes no responsibility for any errors that might appear.
PN9001050Rev. B