SATO CX200 Label Maker User Manual


 
Controls, Indicators, and Connections
Device Name Primary Function Use
FEED Button Advances print media
PRESS - to advance media
PRESS while pressing READY
indicator - to print test label
PRESS - to pause printing during
batch mode operation
READY Indicator
ON-OFF Button
Shows printer status
Places printer in On-Line
or Off-Line mode
GREEN - Printer ready for data
OFF - Printer busy, or Off-Line
RED - Printer needs attention
PRESS to switch to/from
Off-Line or to reset the printer
Power Input Connects to power supply
Connect to transformer provided
with printer
Serial Port Data input
DB9 female connector for
connection to host controller,
RS232 interface
Parallel Port Data input
Centronics compatible connector
for connection to host controller
Print Head
Release
Unlocks print head
Push both releases toward rear
of printer to release print head
Top Cover
Protects print media and
mechanism
Lift to open
Push outward at hinge to remove
Printer Power Connection
1. Plug the output of the AC power supply
provided with the printer into the connec-
tor on the bottom panel.
2. Connect the supply into an AC outlet
having the proper voltage.
Note:
CX200 printers consume very little power when
idle, so are not equipped with a power switch.
Pressing the READY indicator/ON-OFF (a com-
bined control) will reset the printer and switch it
from Off-Line to On-Line mode.
Important!
The required AC voltage is marked on the power supply.
Confirm that your AC voltage matches the power supply
requirements. Do not use any power supply other than
the one provided with the printer.
CX200 User's Guide
Page 2PN9001050 Rev.B