Filter
Top Products
43
## Contact your nearest service center or dealer.
--> Cause Clearing Method
A 1 The battery is not fully charged. 1 Charge the battery.
B 1 Interface module is in abnormal
condition, (Bluetooth or wireless
LAN)
1 Replace the board. ##
C 1 A FLASH ROM reading/writing
error has occured.
1 Replace the FLASH ROM.##
2 Re-download the program.##
D 1 The head has a broken wire. 1 Replace the head.##
E 1 The cover is not locked.
2 Cover opening/closing sensor is in
abnormal condition.
1 Lock the cover.
2 Adjust the sensor.##
F 1 Out of labels. 1 Set a new roll of labels.
G 1 The sensor level is incorrect.
2 The sensor type is incorrect.
3 The paper is misrouted.
1 Adjust the sensor level.##
2 Match the sensor type.
3 Remove & correctly place label roll.
H 1 The communication conditions are
incorrect.
2 Cable connection is in abnormal
condition.
1 Correct the communication condi-
tions.
2 Check the cable connections.
I 1 The receiving buffer is running out
of capacity.
1 Pause host data transmission, wait
for the buffer to empty, then retrans-
mit data.
J 1 Data has exceeded the receiving
buffer capacity.
2 The communication conditions are
incorrect.
1 Transmit data corresponding with
the communication conditions.
2 Correct the communication condi-
tions.
K 1 This is not an error.
The printer is operating in low power
consumption mode.
1 Clear by pressing a button, receiving
data, or opening/closing the main
cover.
L 1 This is not an error.
The head overheating protection
function operates when the head
temperature exceeds 70°C.
1 This is cleared when the head tem-
perature falls to 55°C.
M 1 This is not an error.
2 Press the PRINT button to print
one label.
1 Automatically cleared when the des-
ignated number of labels are printed.