Filter
Top Products
36 SBC-350A User's Manual
Enable
16-bit ISA Cycle Insert Wait 0 w/s (default)
1 w/s
Slow Refresh Disable
Enable (default)
Refresh Type CAS/RAS (default)
RAS only
IO Recovery Disable (default)
Enable
On Chip I/O Recovery Disable (default)
Enable
I/O Recover Period Define 0 (default) ....3750ns, 250
ns/step
Auto Configuration with BIOS Defaults
This main menu option loads the system default values stored in
the BIOS ROM at the factory.
Auto Configuration with Power-On Defaults
This main menu option loads the settings stored in the CMOS
memory when you turned on your system. If your system behaves
erratically, you can use this feature to check for incorrect settings.
Auto Detect Hard Disk
This option simplifies the hard disk drive configuration by auto-
matically configuring the system to your HDD
Hard Disk Utility
This option lets you perform low-level hard disk drive preparation
before you use the DOS FDISK or FORMAT utilities. All of its
functions are destructive to existing data on the disk drive.
Most IDE hard drives come preformatted from the factory, so you
will probably only need these utilities if your hard disk develops
bad sectors or ages and needs to have the formatting information
refreshed.
Write to CMOS and Exit/Do not Exit
After you have made your configuration changes, select Write to
CMOS and Exit. If you decide you want to abandon the changes
you have made, select Do not Write to CMOS and Exit.
The BIOS will then perform a memory test, and attempt to boot