Filter
Top Products
Loading the Thermal Paper
23
1. Installation
Replacing the thermal paper
When the paper runs out, OUT OF PAPER will appear in the display.
Reception and copying will no longer be possible. To replace the
paper, first take out the old roll, then load the new roll as described
above.
To assure a long life for your fax and obtain the best reproduction
quality, we recommend that you use the following Sharp thermal
paper, which is available from your dealer or retailer:
FO-20PRw THERMAL PAPER (30 m roll)
The use of any other paper may result in poor copy quality and
excessive build-up of residue on the head.
Handling thermal paper
Do not unpack the paper until you are ready to use it. It may become
discoloured if:
♦
It is stored at high humidity or high temperature.
♦
It is exposed to direct sunlight.
♦
It comes in contact with glue, thinner, or a freshly copied blueprint.
♦
A rubber eraser or adhesive tape is used on it, or it is scratched.
8
Close the operation panel, making
sure it clicks into place.
•
FO-50:
A short length of the paper
will feed out. Grasp the paper by
the edge and pull upward to tear it
off.
•
FO-70:
A short length of the paper
will be cut off.
Click!
all-Fo50A.book Page 23 Friday, October 1, 1999 5:32 PM