Filter
Top Products
Messages and Signals
95
10. Trouble-
shooting
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in Chapter 7
for display messages related to Caller ID.
CHECK PAPER The thermal paper is jammed or isn’t loaded properly.
Remove and reload the paper. (See the following
section, Clearing Paper Jams.)
COVER OPEN The operation panel is open. Close it.
DOCUMENT JAMMED The original document is jammed. See the following
section, Clearing Paper Jams.
FUNCTION MODE The
FUNCTION
key has been pressed.
HOLD The
HOLD/SEARCH
key has been pressed to put the
other party on hold during a phone conversation.
Press the
HOLD/SEARCH
key again to take the
other party off hold.
LINE BUSY This appears if you attempt to send a fax by
automatic dialing and the line is busy or the receiving
fax machine doesn’t answer (even after automatic
redialing). Press the
STOP
key to clear the message.
LINE ERROR Transmission or reception was not successful. Press
the
STOP
key to clear the message and then try
again. If the error persists, see Line Error in Problems
and Solutions in this chapter.
NO DATA This appears if you attempt to search for an
automatic dialling number when none have been
stored.
NO # STORED You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn’t been programmed (a full
number hasn’t been assigned to it).
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the
STOP
key to clear the message.
all-Fo50A.book Page 95 Friday, October 1, 1999 5:32 PM