Filter
Top Products
Optional Settings
104
Setting 20: ANTI-JUNK FAX
Press to block reception from fax numbers entered in the Anti Junk Fax
List. Press to allow reception from all numbers.
♦ Initial setting: 2
Setting 21: ALARM VOLUME
This sets the volume of the beep sound that alerts you to error conditions and
informs you that operations have been completed. Press for HIGH,
for LOW, or for OFF.
♦ Initial setting: 2
Setting 22: DIAL MODE
This sets the dial mode. Press if you are on a touch-tone line, or if
you are on a pulse dial (rotary) line.
♦ Initial setting: 1
Note: For all units installed in New Zealand, select "1" for tone dialling. The pulse
setting "2" will not operate correctly and must not be used.
Setting 23: QUICK ON-LINE
When you transmit a multi-page document, this setting determines whether
the fax machine will dial the receiving party and begin transmitting while
scanning is still in progress, or wait until all pages have been scanned before
dialling. Press to have the fax machine dial and begin transmission while
scanning is still in progress, or to have the fax machine wait until all pages
have been scanned.
♦ Initial setting: 1
Setting 24: MULTI TTI
If you are using Department Control, you can press to have the
department name (the name associated with the department code entered by
an operator to access the fax) appear at the top of each transmitted
document. This will appear in place of the name entered in
Entering Your
Name and Fax Number
in Chapter 1. Press to turn Multi TTI off (the
sender’s name entered in Chapter 1 will appear).
♦ Initial setting: 2
1
2
1 2
3
1 2
1
2
1
2