Filter
Top Products
6-2
PROGRAMMING
Auto dial numbers (one-touch keys and group keys), user indexes, and memory boxes are stored, edited and deleted
at the operation panel of the machine.
STORING, EDITING, AND DELETING
AUTO DIAL KEYS AND PROGRAMS
This section explains the procedures for storing, editing, and deleting auto-dial keys (one-touch keys and group keys)
and programs, which simplify the transmission procedure. (The procedure for using one-touch keys and group keys
is explained in "TRANSMISSION BY AUTO-DIALING" on page 2-4 and the procedure for using programs is
explained in "USING A PROGRAM" on page 3-17.)
A combined total of 999 (maximum of 500 on the AR-M351U/AR-M451U) one-touch keys and group keys can be
stored, and eight programs can be stored. If you attempt to store more than this, a warning message will appear. In
this case, delete any auto-dial keys or programs that are no longer needed (refer to pages 6-5, 6-7 and 6-8), and then
store the new auto-dial key or program.
To store, edit, or delete an auto-dial key (one-touch key or group key) or program, first follow steps 1 through 4 below.
In the screen of step 4, touch the appropriate key for storing, editing, or deleting.
1
Press the [CUSTOM SETTINGS] key.
2
Touch the [ADDRESS CONTROL] key.
3
Touch the [DIRECT ADDRESS /
PROGRAM] key.
The direct address /
program menu appears.
4
Touch the desired key and perform the
programming operation.
Refer to the pages indicated below for the
operation you wish to perform.
NOTE
To cancel a storing, editing, or deleting operation, press the [CA] key. You will return to the main screen.
ADDRESS CONTROL SEN
DOCUMENT FILING
CONTROL
DIRECT ADDRESS PROGRAM
CUSTOM INDEX
CUSTOM SETTINGS
DIRECT ADDRESS / PROGRAM
INDIVIDUAL GROUP
STORE
OK
PROGRAM
AMEND/DELETE
[INDIVIDUAL] key
Store a one-touch
dial key (following
page)
[PROGRAM] key
Store a program key
(page 6-8)
[GROUP] key
Store a group key
(page 6-6)
[AMEND/DELETE]
key
• One-touch key
(page 6-5)
• Group key (page 6-7)
• Program (page 6-8)
NOTE
Destinations in programs must be stored using one-touch keys. For this reason, if no one-touch keys have been
stored, the [PROGRAM] key will be greyed out.