Filter
Top Products
2
Basic Information &
Preparations
WARNING:
This is a class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
WARNING:
The cooling fan in this projector continues to run for about 90 seconds after the projector is turned off.
During normal operation, when turning the power off always use the POWER ON/OFF button on the
projector or the remote control. Ensure the cooling fan has stopped before disconnecting the power
cord.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE
POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.
Caution Concerning the Lamp Replacement
See “Replacing the Projection Lamp” on page 37.
Bij dit product zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze niet
weggooien maar inleveren als KCA.
For Netherlands Only
CAUTION
HOT SURFACE. REPLACE WITH SAME
SHARP LAMP UNIT TYPE BQC-PGM10X//1 ONLY. UV RADIATION :
CAN CAUSE EYE DAMAGE. TURN OFF LAMP BEFORE SERVICING.
MEDIUM PRESSURE LAMP : RISK OF EXPLOSION. POTENTIAL
HAZARD OF GLASS PARTICLES IF LAMP HAS RUPTURED.
HANDLE WITH CARE. SEE OPERATION MANUAL.
ATTENTION
SURFACE CHAUDE.
NE REMPLACER QUE PAR UNE UNITE DE LAMPE SHARP DE TYPE
BQC-PMG10X//1. RAYONS ULTRAVIOLETS : PEUVENT
ENDOMMAGER LES YEUX. ETEINDRE LA LAMPE AVANT DE
PROCEDER A L'ENTRETIEN. LAMPE A MOYENNE PRESSION :
RISQUE D'EXPLOSION. DANGER POTENTIEL DE PARTICULES DE
VERRE EN CAS DE RUPTURE DE LA LAMPE. A MANIPULER AVEC
PRECAUTION, SE REPORTER AU MODE D'EMPLOI.