Filter
Top Products
22
E
Mounting the Temporary Stands
Temporary
stand
Screw
123
Hole for the
AC cord clamp
Fastened
part
Band
Bundling Cables
The AC cord can be fastened using the supplied AC cord clamp. This will prevent the AC cord from falling
off.
Also, the cables connected to the terminals on the back of the monitor from the external equipment can be
neatly bundled using the supplied cable clamps as shown in the illustration below. This will prevent stray or
disorganized cables at the back of the monitor.
Please note that the temporary stands are for temporary use only until the monitor is properly mounted.
Attach each temporary stand to the bottom of the monitor as shown below.
▼ Rear view
▼ Rear view
Fastening the AC cord
1. Attach the supplied AC cord clamp to the AC cord, making sure the AC cord clamp is circular hole-side
down.
2. Insert the tip of the band into the hole for the AC cord clamp.
3. While holding the tail of the band, slide the fastened part toward the AC input terminal.