Filter
Top Products
Connecting the Power Cord
15
1. Installation
Connecting the Power Cord
Plug the power cord into a 220-230 V, 50 Hz, earthed AC (2-prong) outlet.
Caution!
♦ Make sure you have removed all of the packing tape before plugging
in the power cord (see page 11). Plugging in the power cord without doing
so may damage the machine.
♦ The power outlet must be installed near the equipment and must be easily
accessible.
Note: If your area experiences a high incidence of lightning or power surges,
we recommend that you install surge protectors for the power and telephone
lines. Surge protectors can be purchased at most telephone specialty stores.
“CHECK CARTRIDGE” normally
appears in the display the first
time you plug in the machine.
This message appears until you
install the print cartridge.
The machine does not have a power on/off switch, so the power is turned on
and off by simply plugging in or unplugging the power cord.
all.book Page 15 Tuesday, June 1, 2004 4:24 PM