Filter
Top Products
Maintenance
90
4
Wipe the scanning glass (exposed by
removing the white roller) and rollers
with a clean cloth.
• Make sure that all dirt and stains (such
as correcting fluid) are removed. Dirt
and stains will cause vertical lines on
transmitted images and copies.
If the scanning glass is difficult to clean
If you find it difficult to remove dirt from the scanning glass, you can try moistening
the swab with isopropyl alcohol or denatured alcohol. Take care that no alcohol
gets on the rollers.
5
Replace the white roller, inserting the right end first.
• When re-inserting the roller do not use excessive force to locate the right
hand end. This may result in damage to the machine.
6
Push the green lever up and back. Make sure that the small knob on the
lever goes into the hole on the side of the compartment.
1
2
all.book Page 90 Tuesday, June 1, 2004 4:24 PM