Sharp UX-B30 Fax Machine User Manual


 
Auto-Cordless Fax Control (answering with an extension phone in TEL mode)
62
1
Answer the extension phone when it
rings.
2
If you hear a soft fax tone, wait until your fax responds (the extension
phone will go dead), then hang up.
3
If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press once and twice on the extension
phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.
The above step is necessary if you have set the Fax Signal Receive setting
to NO.
Your fax will not accept the signal to begin reception ( ) if a
document is loaded in its feeder.
Phone goes dead
Beep
Auto-Cordless Fax Control
(answering with an extension phone in TEL
mode)
Important: If a document is loaded in the machine’s feeder, remove it before
performing the steps below. (Fax reception is not possible when a document
is in the feeder.)
You can also start fax reception in TEL mode by answering any extension
phone connected to the same line as the fax machine-even a cordless phone.
all.book Page 62 Tuesday, June 1, 2004 4:24 PM