Filter
Top Products
107
9.
While holding down the paper, slowly close the print roller arm
of the journal side, and push down the arm until you hear a click
locking the arm.
10.
Remove the paper holding plate from the spool.
Insert the end of the paper into the slit in the spool. (Press the
journal paper feed key to feed more paper if required.)
Wind the paper two or three turns around the spool shaft.
11.
Mount the paper holding plate onto the take-up spool.
Set the spool on the bearing, and press the journal paper feed
key to take up excess slack in the paper.
12.
Replace the printer cover.
13.
For the receipt paper, press the
{
key to make sure the paper
end comes out of the printer cover and clean paper appears.
NOTE
If the paper end does not come out, open the printer
cover, and pass the paper end between the paper
cutter and the paper guide of the printer cover, and
replace the printer cover.
Paper positioning
guides
Spool
Paper holding
plate