Filter
Top Products
E-14
Adjusting the Height of the Picture
■ When adjustments for the projector position cannot be made using the Lens Shift alone, or when the projector
stand is on an angle, use the adjuster release to adjust the vertical angle of the projector. Minor adjustments can
be made with the adjusters.
Transporting the Projector
Use the carrying handle when carrying the projector.
When transporting the projector, carry it by the handle located on the side
of the unit.
Note:
• Always put on the lens cap to prevent damage to the lens when trans-
porting the projector.
Caution:
• Do not lift or carry the projector by the lens or the lens cap as this may
damage the lens.
3
1. Press the adjuster release and lift the
projector to the desired angle with both
hands.
• The adjuster legs will extend to the surface of the table.
2. Remove your hand from the adjuster
release.
• The adjuster legs will lock in position. Release the
projector once you are sure the adjuster legs have
locked in position.
3. Make any minor adjustments necessary.
• Turn the adjusters to further adjust the angle of the
projector.
Returning the projector to its original position
• While holding the projector with both hands, press the
adjuster release and slowly lower the projector to its
original position.
Notes:
• Adjustable up to approximately 5° from the horizontal.
• When adjustments are made with the adjusters, the picture may
become distorted, depending on the relative positions of the projector
and the screen.
• After adjusting, in some cases, all of the adjuster legs may not be
resting on the table.
To prevent the projector from wobbling, adjust the adjuster legs so that
they firmly contact the table.
Cautions:
• Do not press the adjuster release when the adjuster legs are extended
without firmly holding the projector.
• When lowering the projector, be careful not to get your fingers caught
in the area between the adjusters and the projector.
• Do not hold the lens when lifting or lowering the projector.
2
1
Carrying handle
Adjusters
Adjuster release