Filter
Top Products
E-25
6. Select input.
Press the INPUT SELECT button on the projector to
switch the picture input. When you press the button, the
current input mode is displayed for about 4 seconds. If
you press the button again while the input mode is
displayed, the mode changes as shown on the left.
Confirm the selected input terminal and press the INPUT
SELECT button.
Notes:
• This can be selected directly using the VIDEO 1, VIDEO 2, DATA 1
and DATA 2 buttons on the remote control.
• In VIDEO mode, the system being received will be indicated below the
“VIDEO” display.
• When selecting RGB mode, the resolution being displayed will be
indicated under “RGB,” as shown on the left. (Refer to the second
example when connecting to Mac display.)
• When no signals are being received, “NO SIGNAL” will be displayed.
When receiving a signal the projector is not preset to receive, “NOT
REG.” will be displayed. (This display function does not operate in
Video mode.)
• The picture size differs in RGB, NTSC, PAL and SECAM INPUT
modes.
7. Press INPUT CHECK.
When the INPUT CHECK button on the remote control is
pressed, the current input mode is displayed for about 4
seconds.
Note:
• The INPUT CHECK button will not function if the INPUT DISPLAY is
turned off, as described on page 30.
8. Adjust the volume.
Press the VOLUME UP-DOWN buttons on the projector
or on the remote control to adjust the volume.
MUTE
• Press the MUTE button to temporarily turn off the
sound.
• Press the MUTE button once again to turn the sound
back on.
9. To turn off the power from the projector
or remote control
• Press the POWER ON/OFF button on either the projector or
the remote control. The screen on the left will appear.
• If you want to turn off the power, press the POWER ON/OFF
button on either the projector or the remote control again
within 4 seconds. The power is now temporarily turned off.
• If you accidentally pressed the POWER ON/OFF button and
do not want to turn off the power, wait until the On-Screen
Display disappears before turning the power on again.
The POWER indicator will turn red and the cooling fan will
run for 90 seconds, then the power will turn off, and the
projector will return to STANDBY mode.
The power can be turned on again either from the projector
or remote control. When the power is turned on, the
POWER indicator and LAMP REPLACEMENT indicator
light green.
Note:
• When the MAIN POWER is off on the projector set, the power cannot
be turned on from the remote control.
On-Screen Display
For viewing the picture from a
video source connected to: VIDEO
INPUT 1 or S-VIDEO INPUT
COMPUTER
RGB2
COMPUTER
RGB1
VIDEO INPUT 2
VOLUME
38
Mac
Mac
8
7
6
ON/OFF
POWER
LAMP
TEMP.
9
TURN POWER OFF?
YES:PRESS
NO:PLEASE WAIT
AGAIN
The number of displayed
segments (0~60) increases
or decreases as the volume
is raised or lowered.