Shiro ADSL 2/2+ Ethernet Modem Modem User Manual


 
User Manual
Page 15 of 92
Hardware Setup
When installing the router, the common practice is to have the router, the main computer, and phone
jack in the same room. The room should also have enough electrical outlets to match your needs.
The following hardware setup samples depict two scenarios – Bridge Connection and Direct
Connection.
Bridge Connection
This device is preconfigured to function as a bridge connector between the Internet service and the
local network. In this setup, the router acts as a dialer for a broadband router. To connect to the
Internet,
To setup a bridge connection:
1. Plug one end of the telephone cable from the POTS Splitter’s ADSL port and then plug the
other end into the router’s DSL port