Support User Manuals

Sierra Wireless 20070914 Modem User Manual

Open as PDF

of 159

Configuration Commands

Rev 3.0B Feb.08 105

*DU=n

ThedialcommandalwaysusesUDP,ev enwhenusingATDT.

• n=0:Dialusingthemeansspecified(default).

• n=1:DialUDPalways,evenwhenusingATDT.

Note: When this parameter is set you cannot establish a TCP PAD

connection.

*UALL=n

AcceptsUDPpacketsfromany IPaddresswhenaUDP

sessionisactive.IfthereisnoUDPsessionactive,anincoming

UDPpacketwillbetreatedaccordingtotheUDPautoanswer

andAIPsettings.

• n=0:Noeffect(Default).

• n=1:AcceptUDPdatafromallIPaddresseswhenina

UDPsession.

*UDPLAST=n

Note: *UDPLAST does not

change the S53 setting in

NVRAM. If the modem is reset,

the original S53 setting will be

restored from NVRAM.

Ifenabled,setsS53tothelastacceptedIPaddressthrough

UDPautoanswer.ThiscanbeusedinconjunctionwithMD3

sothatwhenthereisnoUDPsession,newethernethostdata

willcauseaconnectiontoberestoredtothelastIPaccepted

throughUDPautoanswer.

• n=0:DoesnotchangeS53setting.(Default).

• n=1:SetS53tothelastacceptedIP.

*USD=n

WaitsthespecifieddelaybeforesendingthefirstUDPpacket

andthesubsequentUDPpacketsouttotheportEthernet.

• n=0:NoUDPpacketdelay(Default).

• n=1‐255:Delayin100msunits,from100msto25.5sec.

DNS

Thisgroupincludescommandsspecifictothemodembeing

abletousedomainnamesinsteadofIPaddressesforother

configurationoptions.

previous next