Support User Manuals

Sierra Wireless 20070914 Modem User Manual

Open as PDF

of 159

Circuit Switch Communications

Rev 3.0B Feb.08 133

Figure 2-17: HyperTerminal

4. Enterthecommand:AT+WVCLASS?.Confirm

thataresponseofʺ+WVCLASS:9ʺisreturned.

5. Enterthecommand:ATS0?.Confirmthata

responseofʺ001ʺisreturned.

Note: The dial test should be

completed with the serial cable

disconnected to verify that no

signaling is required by the

modem.

c. DialtheRavenmodemtelephonenumberfromaland

lineandverifythatthemodemautomatically answers

thecallwithmodemtones.

d. Verifyoutgoingcalls.

1. Connectthemodemtoyourcomputerwitha

serialcable.Usingaterminalemulationprogram

(HyperTerminal)setupfor9600bps,8databits,no

parityand1stopbit.

2. Enterthecommand:ATD[phone number].Forthe

[phonenumber],enteraknownphonenumber

includingtheareacodeforwhichyoucan hear

ring(suchasyourofficephone).

14. Commission the Raven Modem on

Site.

Thefollowingstepsrepresentaguidelineandmakesassump‐

tionsthatthemodemhasbeenverifiedpreviouslyina

controlledenvironment.

a. InstalltheRavenmodemverifyingthatallpowerand

antennacablesarecorrectlysecured.

previous next