Filter
Top Products
4
Note: If you like to monitor disk activity of the
Serial ATA hard drives, you may at this time connect
the hard disk LED of the system case to the Hard
Disk LED Pins on the Serial ATA controller, see
Figure 1, on page 2 for the location of the pins. For
most systems connect the red wire to the pin located
farthest from the mounting bracket.
6. Replace the computer cover and reconnect the power
cord. Go to Driver Installation to install the Serial
ATA 4-Channel PCI device driver.
Driver Installation
This section provides information on how to install the
Serial ATA 4-Channel PCI drivers.
Windows 2000
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the NT4 folder, found on the driver
CD, onto a blank floppy disk then follow the directions
below.
For New Installation
1. Install the board and follow Microsoft procedures
to install Windows 2000 accordingly.
2. At the Windows 2000 Setup screen, press F6 to
install the driver.
3. Insert the floppy disk that you made above. Press S,
then press Enter.
4. Select Silicon Image SiI... Controller for Windows
NT4.0 and 2000, press Enter.
5. Press Enter again to continue and follow on-screen
instructions to complete the installation.