Filter
Top Products
6
2. At the Found New Hardware Wizard:
XP (w/SP1 or earlier)/Server 2003: continue to step #3.
XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select
No, not at this time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), and click Next.
4. Click Finish and restart Windows to complete the
installation.
Windows XP / Server 2003 (64-bit)
For New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the 64bit folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1. Install the board and follow Microsoft procedures
to install Windows accordingly.
2. At the Windows Setup screen, press F6 to install the
driver.
3. Insert the floppy disk that you made above. Press S
then press Enter.
4. Select Silicon Image SiI... that matches your system
processor, then press Enter.
5. Press Enter to continue and follow the on-screen
instructions to complete the installation.
Note: If prompted, press Continue Anyway several
times to install the driver.
For Existing Installation
1. Install the board and boot up Windows.
2. At the Found New Hardware Wizard, select No, not
at this time, then click Next.