Filter
Top Products
10
6. Press F10 to exit the BIOS. When asked Do
you want to exit from Marvell BIOS Setup?
press Y to exit and reboot.
RAID 10 (Mirror+Striping)
Four drives are needed to make a RAID10.
1. As the BIOS boots, press Ctrl+M when
prompted to enter the RAID BIOS.
2. At the next screen select HBA 0: Marvell 0,
press Enter. Select Configuration Wizard,
then press Enter.
3. Use Up or Down arrow key to choose hard
drive. Press Spacebar to select the hard
drive. Perform the same procedure with
the other hard drives. Once all hard drives
are selected press Enter.
4. Select RAID Level or HyperDuo, press
Enter. Select RAID10, then press Enter.
Note: You can rename the VD Name. This
is optional.
5. Select Next, press Enter. When asked Do
you want to create this virtual disk? press
Y to select Yes.