Filter
Top Products
8
RAID 0 (Striping)
This RAID array to be used on New/Blank hard
drives. Striping will destroy data on the hard
drive. A minimum of 2 drives are needed to
configure this array.
1. As the BIOS boots, press Ctrl+M when
prompted to enter the RAID BIOS.
2. At the next screen select HBA 0: Marvell
0, press Enter. Select Configuration
Wizard, then press Enter.
3. Use the Up or Down arrow key to choose a
hard drive. Press the Spacebar to select the
hard drive. Perform the same procedure
with the other hard drive(s), you want to
add to the array. When you are finished
selecting the hard drives, press Enter.
4. Select RAID Level or HyperDuo, press
Enter. Select RAID 0, then press Enter.
Note: You can rename the VD Name. This
is optional.
5. Select Next, press Enter. When asked Do
you want to create this virtual disk? press
Y to select Yes.