9
6. Press F10 to exit the BIOS. When asked Do
you want to exit from Marvell BIOS Setup?
press Y to exit and reboot.
RAID 1 (Mirror)
Two drives are needed to make a Mirror.
1. As the BIOS boots, press Ctrl+M when
prompted to enter the RAID BIOS.
2. At the next screen select HBA 0: Marvell 0,
press Enter. Select Configuration Wizard,
then press Enter.
3. Use Up or Down arrow key to choose a
hard drive. Press Spacebar to select the
hard drive. Perform the same procedure
with the other hard drive. Once both hard
drives are selected press Enter.
4. Select RAID Level or HyperDuo, press
Enter. Select RAID1, then press Enter.
Note: You can rename the VD Name. This
is optional.
5. Select Next, press Enter. When asked Do
you want to create this virtual disk? press
Y to select Yes.