Filter
Top Products
Command Description
SET NW
WPATRACE
Sets WPA trace level.
This command is for internal diagnostic purposes only.
The default value is 0 or disabled.
Format:
SET NW WPATRACE nn
NOTE: For FIPS 140-2 approved operation, this parameter must be 0
SH NW DISCONN Displays the current value of the network disconnection timer
Sample output:
Disconnect Timer: 5
SET NW
DISCONN
Sets the period of the network link disconnection watchdog timer. In wireless
infrastructure mode, this timer monitors the wireless link, and if the unit is not
connected to an AP for the time specified, the unit is reset.
SET NW DISCONN nn
N = 0 watchdog timer is disabled
1-255 watchdog timer period in minutes
The factory default value is 5 minutes.
This timer also controls a receive activity monitor when the wireless network link is
connected. If no packets are received during the time specified, and the link remains
up, the unit will reset at the end of the time period.
SET NW RESET This command stops, and then resets the wireless network interface. This will
effectively disassociate the unit from an access point if it is connected. If the unit is
in wireless infrastructure mode, the unit will then scan and attempt to reconnect to a
suitable access point, if one is available.
Format:
SET NW RESET
ZEROKEYS Zeroizes the module private key and WPA PSK key, as well as any temporary key
values held in RAM. The unit will then automatically perform a soft reset. Note that
if any wireless encryption is enabled, it will be impossible to connect to an access
point until the necessary key information has been re-configured.
Port Commands
Table 12 Port Commands
Command Description
SH PORT Shows port parameters
Sample output:
Port Q-Size Type Attributes
*S1 0 serial 115200 N 8 1 XON/XOFF
CLEAR PORT S1
JOB
Aborts the active job on the port.
Console Commands Silex Page 46
Part Number 140-00188-210A