SimpleTech ZeusIOPS Network Card User Manual


 
62 Zeus
IOPS
3.5-Inch Fibre Channel Solid State Drive Product Manual Rev. 1.0
INSTALLATION
SYSTEM REQUIREMENTS
SCSI CONNECTIONS
The Zeus
IOPS
3.5-inch Fibre Channel SSD can be installed in an operating system environment that
supports SCSI-3 or greater devices (the SSDs are intended to be compliant to future SCSI-4
standards). If the system does not have a Fibre Channel AL-Port, the user will need to supply and
install an adapter before proceeding with the installation. If the system fails to recognize the drive,
make sure the most recent drivers for the host adapter are installed. If the drive is connected to the
motherboard, the drivers are provided by the motherboard manufacturer. Changes to the operating
system are not required.
Make sure the following is on hand before installing the SSD:
Phillips screwdriver
Six M3 machine screws
A cable suitable to connect the backplane or tailgate card to the HBA
An available tailgate card or backplane connection.
Available 12V power source
SINGLE CHANNEL OPERATION
The Zeus
IOPS
SSD is dual-ported and can be accessed simultaneously down both ports or channels.
This allows the drive to be used on systems that have multi-pathing software, also known as
“Dynamic Multi-Pathing” or DMP. The DMP software allows for two completely separate paths from
the one host machine to access the same drive; the two separate paths are recognized as being
logically connected together. This allows for some redundancy to be incorporated into the system.
Systems that support DMP typically send commands to the drive down both channels, using the
channel that is the least busy. If one channel fails for any reason then all commands are automatically
switched to use the remaining active channel.
There is a risk of electrocution! Use extreme caution when
handling the solid state drive and while connecting it to a
power source. Observe all applicable electrical safety rules
while installing the solid state drive. Make sure to read and
thoroughly understand this section before attempting to
install the drive.