Filter
Top Products
A P P E N D I X C
Disablinguser USBaccess
99 smarttech.com/kb/170585
To remove the USB jumper switch
1. Locate the USB jumper behind the jumper cover port.
2. Using needle-nose pliers, pull the jumper from the two connection posts, and then place it on a
single post.
I M P O R T A N T
o
Only adjust the jumper position. Do not adjust the PC/SE240 switch, which is also
accessible from this area.
o
Do not discard the jumper. Discarding the jumper makes the USB deactivation difficult to
reverse.
3. Insert the USB jumper cover into the USB A port on the front of the ECP.
4. Connect all cables to the ECP. See the Using the Extended Control Panel (ECP) on page 23 for
more information.
5. Secure the ECP to your interactive whiteboard with the two screws you removed previously.
6. Connect the projector’s power cable to the power outlet.