Filter
Top Products
22 | CHAPTER 3 – CONNECTING YOUR INTERACTIVE WHITEBOARD TO YOUR
COMPUTER
To install the USB driver
(Windows only)
1. Click Next to direct the wizard to search for an appropriate driver.
2. Click Next again to direct your computer’s operating system to search the driver
database on your hard drive for the appropriate driver.
NOTE
If the Windows operating system doesn’t find the correct driver, insert the
Windows CD in your CD drive, and then install a USB HID driver. Because
USB HID is a subclass of USB devices, the drivers aren’t always included in a
default installation. You must install these drivers on your computer before the
included USB cable will work properly.
3. Click Finish after the driver search or driver installation finishes.
The Ready light turns red and then flashes green, indicating that the controller
is receiving power from the USB connection and is operating in HID mouse mode.
You should now install SMART Product Drivers.
Installing SMART Product Drivers
After you install SMART Product Drivers on your computer, your SMART Board
interactive whiteboard’s display will respond to the touch of your finger or a pen tray
pen on its screen surface. SMART Product Drivers includes the tools that you need
to control computer applications with your finger or a pen, and to write over them in
digital ink.
To install
SMART Product Drivers
on a Windows computer
1. If necessary, press the power button on your projector to see the projected
computer image on your screen.
2. Insert the included SMART Product Drivers CD in your computer’s CD drive
to launch the software installation screen.
NOTES
– If the CD doesn’t run automatically, select Start > Run, type
x:\autorun.exe in the Run window (where “x” is the letter of your CD
drive), and then click OK.
– Alternatively, you can download SMART Product Drivers from the SMART
Support website. To do this, go to the SMART Notebook software for
Windows operating systems support page and select download SMART
Product Drivers only.