Filter
Top Products
Chapter 5 Control From Editing
Control Units
5-14 Chapter 5 Control From Editing Control Units
Preread Editing
Notes on preread editing
• A BVE-2000 Ver. 2.24 or later is recommended as the editor.
In this case, set PREVIEW MODE to FULL, and use a monitor
connected to the DFS-700 PROGRAM OUT.
If using a BVE-2000 earlier than Ver. 2.24 or another editor, previewing
is not possible.
• It is not possible to set the DFS-700 preread mode from the editor.
It must be set manually.
For an editor other than the BVE-2000, it is not possible to set the preread
mode for the VTR. It must be set manually.
• During preread editing, the effect patterns which can be used are
restricted to those for which a title can be used automatically.
• During normal editing the video output is delayed by one frame, but
during preread editing, the video selected on the background bus only is
delayed by 4H.
When carrying out R to P or P to R editing make sure that the background
bus signal is available to the R.
• To obtain the DFS-700/700P program output, use digital PGM OUT or
analog component PGM OUT connectors on the DFS-700/700P
processor unit.
Settings for preread editing
Preparations on the DFS-700/700P
In page 1 of the setup menu, set F2(PRE_RD) to ON. When PRE_RD is
set to ON, a "P" appears at the beginning of line 2 of the menu display,
indicating preread mode. (Except during preread editing, if PRE_RD is set
to ON the edit points will be shifted, so be sure to set it to OFF. It is not
possible to make this setting from the editor.)
Preparations on a BVE-2000 earlier than Ver. 2.24
Set AUX F7(PREREAD) to ON.
Preparations on a BVE-2000 Ver. 2.24 or later
• In SYSTEM SETUP mode set the PREVIEW MODE of SW'ER
CONFIGURATION to FULL.
• Set AUX F7(PREREAD) to ON.
• In SYSTEM SETUP mode set the DIGITAL EFFECT DELAY of
SYSTEM CONFIGURATION to 01.