Sony SDX-800V Computer Drive User Manual


 
MODE SELECT 6.Command Specification
SONY AIT-3Ex drive SDX-800V series Ver.1.1 6-45
RBO: This field is not supported. If this bit is set a CHECK CONDITION status is returned with an ILLEGAL
REQUEST sense key.
REW: The Report Early-Warning End-of –Media bit is set to ZERO indicates the drive will not report the
early-warning condition on reads but will report early-warning on writes before the physical End-Of –Partition. The
REW bit is changeable. A value of ONE indicates that the drive will report the early-warning condition on writes and
reads.
Gap Size: This field is not used by the SDX-800V and shall be set to ZERO otherwise a CHECK CONDITION with
an ILLEGAL REQUEST sense key will be returned.
EOD Defined: This field shall always be set to ZERO so that the drive will use its default EOD definition to detect and
generate EOD. Any other value will cause the drive to return a CHECK CONDITION status with an ILLEGAL
REQUEST sense key set.
EEG: The Enable EOD Generation bit shall always be set to indicate that drive will generate an EOD. The drive
generates an EOD mark prior to any change of direction, if that change follows a write-type operation. This bit is only
valid on the MODE SENSE command where it is used to report drive capabilities. This bit is ignored by the drive on
a MODE SELECT command. The drive will not return a CHECK CONDITION.
SEW: The Synchronize at Early-Warning bit is set to ONE indicates buffered write data, File-marks and Set-marks at
or after Early-Warning End-of-Media will be written to the Medium. The SEW bit changeable. A value of ZERO
indicates that the target will retain any unwritten buffered data, File-marks, or Set-marks in the buffer when logical
Early-Warning is encountered. The default is 1.
Buffer Size at Early Warning: This field is not supported by the drive and if set a CHECK CONDITION status is
returned with an ILLEGAL REQUEST sense key set.
Select Data Compression Algorithm: The SDX-800V supports the Data Compression Page and that page should
be used instead of this field to control Data Compression. This field is not supported by the drive and if set a CHECK
CONDITION status is returned with an ILLEGAL REQUEST sense key set.