Filter
Top Products
37
GB
Maintenance
Maintenance
4 Insert the new lamp all the way in until
it is securely in place. Tighten the
screws. Fold the handle.
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
5 Close the lamp cover and tighten the
screws.
6 Turn the projector back over.
7 Connect the power cord and turn the
projector to standby mode.
8 Press the following keys on the remote
commander in the following order for
less than five seconds each: RESET,
<, ,, ENTER.
• Be sure to use the LMP-C150 Projector
Lamp for replacement. If you use lamps
other than LMP-C150, the projector may
cause a malfunction.
• Be sure to turn off the projector and unplug
the power cord before replacing the lamp.
• Do not put your hands into the lamp
replacement spot, or not fall any liquid or
object into it to avoid electrical shock or
fire.
The air filter should be cleaned every 300
hours.
Remove dust from the outside of the
ventilation holes with a vacuum cleaner.
When it becomes difficult to remove the dust
from the filter with a vacuum cleaner,
remove the air filter and wash it.
1 Turn off the power and unplug the
power cord.
2 Place a protective sheet (cloth)
beneath the projector and turn the
projector over.
3 Remove the air filter cover.
Notes
Notes
Cleaning the Air Filter