Sony VPL-PX40 Projector User Manual


 
GB
38 Maintenance
B Maintenance
Maintenance
When the lamp has burnt out or dims, or
“Please replace the LAMP.” appears on the
screen, replace the lamp with a new one. Use
LMP-P260 Projector Lamp as the
replacement lamp. The lamp life varies
depending on conditions of use.
When replacing the lamp after using
the projector
Turn off the projector, then unplug the
power cord.
Wait for at least an hour for the lamp to cool.
The lamp becomes a high temperature after
turning off the projector with the I / 1 key. If
you touch the lamp, you may scald your
finger. When you replace the lamp, wait for
at least an hour for the lamp to cool.
If the lamp breaks, consult with qualified
Sony personnel.
Pull out the lamp by holding the handle. If
you touch the lamp, you may be burned or
injured.
When removing the lamp, make sure it
remains horizontal, then pull straight up. Do
not tilt the lamp. If you pull out the lamp
while tilted and if the lamp is broken, the
pieces may scatter, causing injury.
1 Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can see its
underside.
Be sure that the projector is stable after
turning it over.
2 Open the lamp cover by loosening a
screw with the Phillips screwdriver.
For safety sake, do not loosen any other
screws.
3 Loosen the three screws on the lamp
unit with the Phillips screwdriver. Pull
out the lamp unit by the handle.
The screws have washers. Do not
remove the screws, just loosen them.
Replacing the Lamp
Caution
Notes
Note
Note
Note
Handle