Filter
Top Products
7. Hold the memory module by its edge and slide it into the memory module slot
with its end terminal facing downward while aligning the notch on the module
with the small projection in the slot.
8. Hold the memory module by its edge and push in until it clicks into place as
shown in the illustration.
The latches on both sides of the slot snap into place to secure the module. Do
not touch any ICs (black components) on the memory module.
9. Replace the memory module compartment cover and secure it with the screws
you removed in step 3.
10. Install the battery pack and connect all connection cables and peripherals that
you removed in step 1, and turn on the computer.
11. Check that the amount of system memory has correctly changed.
If the amount of indicated system memory is correct, memory module
installation was successful.
To check the system information, see Viewing the System Information.
Go to Page Top
Related Topic
Notes on Adding and Removing Memory Modules
Go to Page Top
© 2013 Sony Corporation
243
Search