Filter
Top Products
38
Installation of the Operation Software
Installation of the
Operation Software
The UCP-8060 is shipped with the operation software for
several products installed. If you wish to use another
product, install the operation software for the product
following the procedures below. It is also necessary to
install operation software when you update the system
files.
You can install the operation software using a Memory
Stick or via the Internet (HTTP server).
To obtain the operation software, consult your Sony
representative..
Note
The memory capacity to store the operation software is
limited. You may remove some operation software when
you intend to install a new software.
For details on the capacity of a Memory Stick, see
“Checking the Information” on page 43.
For details on removing software, see “Removing the
Operation Software” on page 42.
Requirements
• Computer (to enable copying files to a Memory Stick if
a Memory Stick is to be used)
• Operation software to be installed (two files, with the
extensions “jar” and “jad”)
Installation using a Memory Stick
• Memory Stick
Preparations
1
Copy the operation software to a Memory Stick or to
an HTTP server using a computer.
To copy onto a Memory Stick, prepare a folder named
MSSONY/PRO/UCP, and copy to a folder under
UCP.
When you format the Memory Stick on this machine,
the MSSONY/PRO/UCP folder is automatically
created.
Note
If the filename or folder name has any non-ASCII
characters, installation may fail.
2
Turn the UCP-8060 on.
The Main Screen appears.
For details on the IP address of the HTTP server and the
network connection, consult your network administrator.
Installation
Installing using a Memory Stick
1
Insert the Memory Stick in which the operation
software has been copied into the Memory Stick slot.
2
Press the select L button (Menu).
The Menu display appears.
3
Select Install Settings by turning the jog roller, and
press the select R button (Enter).
The Install Settings display appears.
4
Select Memory Stick by turning the jog roller, and
press the select R button (Save).
The Menu display appears.
The procedures below depend on whether operation
software has been installed or not.
If the operation software has been installed
1
Select Install with the jog roller.
2
Press the select R button (Enter).
The Install display appears. Check that a file with the
extension “jad” in the Memory Stick is displayed.
If the file name includes both upper- and lowercase
letters, installation is performed normally.
3
Select the operation software to be installed by
turning the jog roller, then press the select R button
(Go).
Information on the operation software appears.
4
If the displayed information is correct, press the select
R button (Yes).
Installation begins. While reading and writing data,
the status indicator is lit or blinking.
When installation is complete, a message to indicate
this appears on the screen.
Note
While reading and writing data, never turn the power
of the UCP-8060 off, or remove the installed Memory
Stick. The file may be damaged.