Filter
Top Products
9
• [Start up] button
Used to make the initial screen screensaver settings. Touch the [Start up]
button to display settings screen.
- [Startup1] to [Startup4]
Touching the buttons switches the file display [ON] or [OFF].
After the interval set in [Time(sec)] elapses when the initial screen is
displayed, the selected still images or movies (set to [ON]) are displayed
on the screen. [Startup1] to [Startup4] correspond to the files installed as
[Startup1.*] to [Startup4.*].
- [Time(sec)] button
Time interval before the screensaver is displayed. Touch this button to
display the time input (seconds) screen. The interval must be between 1
and 600 seconds.
• [Printing] button
Used to make the settings for the functioning of the screen saver display
during printing. Touch the [Printing] button to display the setting screen.
- [Printing1] to [Printing4]
Touching the buttons switches the file display [ON] or [OFF].
After the interval set in [Time(sec)] elapses when the printing screen is
displayed, the selected still images (set to [ON]) are displayed on the
screen. [Printing1] to [Printing4] correspond to the files installed as
[Printing1.*] to [Printing4.*]
- [Time(sec)] button
Time interval before the screensaver is displayed. Touch this button to
display the time input (seconds) screen. The interval must be between 1
and 600 seconds.
• [Interval] button
Time interval during which the still pictures are displayed (when more than
one file is selected as the screensaver). Touch this button to display the time
input (seconds) screen. The interval must be between 1 and 600 seconds.
Note
• If only one still image is selected as the screensaver, it is displayed
continuously.
• If a movie is selected as the screensaver, the movie plays to its end,
regardless of the [Interval] button setting.
• [Install] button
Touch this button to display the screen where still images or movies are
added. Follow the instructions on the screen to perform the operation.
Modifications to the Diagnostic Function
The diagnostic possible through the Configuration Utility is limited to SCSI
peripheral devices. Replace the information of “[Diagnostic Settings] Screen” in
the User’s Guide with the following.
• [All] button
Touch this button to run a diagnostic of all the SCSI peripheral devices
connected to the UPA-PC100. If an abnormality is detected, a message
appears. For details about messages, refer to the Operating Instructions. Touch
the [OK] button to close the message.
• [UP-DR100], [UP-D70A], [UY-S90/100], [FlatbedScanner] buttons
Touch the appropriate button to run the diagnostic for that device. If an
abnormality is detected, a message appears. For details about messages, refer
to the Operating Instructions. Touch the [OK] button to close the message.
Configuration Utility Setting Management
You can return the Configuration Utility settings to their default settings, as
well as import or export the settings. You can perform this management in the
Configuration Utility, [Setting – Setting] screen.
• [Initialize] button
When you touch this button a message asking you to confirm that you want to
revert to the default settings is displayed. Follow the instructions on the screen
to perform the operation.
• [Import] button
Touch this button to display the setting import screen. Follow the instructions
on the screen to perform the operation.
Note
Before performing this operation, be sure to touch the [Export] button and
save the setting file (*.ini) on a floppy disk.
• [Export] button
Touch this button to display the setting export screen. Follow the instructions
on the screen to perform the operation.
Note
When this operation is performed, the setting file (*.ini) is saved to floppy
disk.