Filter
Top Products
74
Caution messages
Please clean the filter. c It is time to clean the air filter. Clean the air filter (1 page 78).
To clear this message, press any button either on the remote control
or the control panel of the projector once.
Please clean the filter. Have
you finished? Yes No
c It is time to clean the air filter. Clean the air filter (1 page 78).
c If you cleaned the air filter, select “Yes.” If you did not clean the
air filter, select “No.”
Projector temperature is
high. Cooling Setting
should be “High” if
projector is being used at
high altitude.
c Check to ensure that the ventilation holes on the unit are not
covered (1 page 14).
c When using the projector at high altitude, set “Cooling Setting”
to “High” (1 page 58).
When temperature inside the projector remains high, “Cooling
Setting” is switched to “High” in 1 minute, then the fan speed
increases.
Power Saving Mode is set.
Projector lamp will
automatically cutoff in 1
minute.
c “Power Saving” is set to “Lamp Cutoff.” (1 page 59)
If no signal is input, the lamp turns off after 1 minute.
Power Saving Mode is set.
Projector will
automatically enter
Standby Mode in 1 minute.
c “Power Saving” is set to “Standby.” (1 page 59)
If no signal is input, the power turns off after 1 minute, and the
projector goes into standby mode.
Message Cause and Remedy
c No signal is input in the selected input. Check connections
(1 page 25).
Not applicable! c Press the appropriate button.
c The operation to be activated by the button is currently
prohibited.
Message Cause and Remedy
Note
Note
Note
Note
x