Filter
Top Products
20 Start Using Wireless Manager
There may be special circumstances where a GPRS dial-up connection is required for logon.
To create a GPRS dial-up connection, follow these steps:
1. Create the Windows dial-up connection using the Windows Network Connection Wizard.
For the telephone number, use *99***3#.
2. Set the GPRS context parameters in the EDGE PC Card using the following AT commands.
Type the AT Commands into the Windows Hyperterminal program.
AT+CGDCONT=3,“IP”,“<AccessPointName>”,“”,0,0
where <AccessPointName> is the name of the special GPRS access point for your corporate
GPRS service.
Note:
In this example, we used GPRS Context 3. There are 10 possible contexts supported by the
EDGE PC Card (1..10). Context ID 2 is reserved for use by connections created by the
Wireless Manager. The context definition is stored in nonvolatile memory in the EDGE PC card
and only needs to be set up once. Cards could be set up, for example, by the IT Manager using
a different laptop.
Refer to the AT Command Manual or contact your service provider for further assistance.