Filter
Top Products
Secure MICR Printer User’s Guide © Source Technologies
July 2003 Page 1 All rights reserved
1 Printer Installation
For complete information on how to unpack and setup your printer, see your printer’s user’s
guide. Please read the following if you are going to install the printer driver shipped with your
printer.
1. Locate the CD that was shipped with your printer.
Note: If you do not have a CD-ROM drive on the host PC, locate another computer with
a CD-ROM drive, start the CD-ROM utility, and then follow the instructions on the screen
to create printer driver diskettes.
2. Follow the instructions in the CD booklet to start the printer setup utility appropriate
for your operating system, i.e. Windows 95, NT, etc. The setup utility will install
printer driver and utilities to manage Source Technologies printer(s) attached to your
PC or Network.
3. The Source Technologies, in most cases, assumes the printer driver
is set to the internal DEFAULT values. The following Default values should not be
changed for best overall printer performance and data stream requirements of the
ST Secure MICR printer.
- Print Resolution under the Graphic Tab should be set to the Default value of 600
DPI.
- Form Source under the Paper Tab should be set to Default value of By Source.
- Print Quality and PictureGrade under the Graphic Tab should be set to the
Default values of Use Printer Default.
The ST Secure MICR Printer requires a PCL5 or PCL5e data stream. Current level
printer drivers require Graphic Mode under the Graphic Tab be set to either Raster
or GL/2. We recommend Raster. This is the only required non-Default value that
needs to be set in the printer driver.
A majority of other driver options can be set for your particular requirements. The most
obvious of these would be a Paper Tray selection if your application uses the Print Driver
Setting.
Section 1: Printer Installation