Filter
Top Products
Secure MICR Printer User’s Guide © Source Technologies
September 2005
A15 All Rights Reserved
PJL Unlock Sequence
The first two lines of the variable text example are PJL commands that unlock the MICR
font resources and enter PCL language processing. The password used is PASSWORD,
the initial ship default. These commands and all following commands are all case sensitive.
<ESC> is used to illustrate the ASCII Escape Character, ASCII 27, hex 1B. An actual data
stream requires the Escape Character, not <ESC>.
PCL Initial Set-Up
The next two commands set up some printer PCL variables. These commands are
normally early in the data stream. We chose a minimal set. <ESC>&l2a1h6d1e64F sets the
paper size to LETTER, the input tray to TRAY 1, the lines per inch to 6, the top margin to 1,
and the lines per page to 64. The next command, <ESC>&u600D, is the Unit of Measure
command set to 600 dots per inch mentioned in Section 7. This affects proper MICR line
spacing and X and Y cursor positioning.
PCL MACRO Call
The next command calls MACRO 100 that was previously loaded in RAM memory. When
called the graphic background, logos, and static data is written to the internal print buffer.
PCL Font Calls, Positioning Commands and Variable Print Data
The next eleven lines of data in the example call printer resident fonts, position the cursor,
and print the variable information. We are again using the minimal data required,
particularly the font selection strings, <ESC>(s4099t0b10H being a very short version to
call Courier, Normal Weight, 10 Pitch.
<ESC>*p300x600Y is a PCL positioning command. In this case its values are 600 pixels
down and 300 pixels to the right of the upper left corner of the page. The Unit of Measure
command determines the exact distance.
The next 4 lines call our secured MICR font resources. We are using the ID for the font call.
The Form Feed prints the page.
PJL Re-Lock Sequence
The last two lines re-lock the secured fonts. The password is not changed in this example.