Filter
Top Products
SOYO SY-P4VM800 Quick Start Guide
Hard Disk Drive/Floppy Drive/CD-ROM Issues
22. My hard disk drive is not detected during Power Up Self Test routine.
Change the jumper settings of the hard drive to cable select or single.
23. Sometimes the system finds my CD-ROM, and sometimes not
1. Ensure the CD-ROM is working properly.
2. The power supply may not provide enough power for all installed devices. Remove all
redundant devices, such a second hard drive/CD/DVD-ROM/RW, and reboot. If the
system functions normally after the removal some power-consuming devices, there may
be a need for a reduction in installed devices or for a more powerful power supply.
24. When I boot up my newly installed system, the monitor reads "Floppy Boot
Failure" and the LED of the floppy disk does not go out.
Intel USB2.0
Driver
Installation
The SOYO CD
1. Ensure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't trust
the "key lock" or "notch") and use the end-connector of the cable (don't use middle one).
2. Some floppy drivers have their own jumper to make the same twist as the twist on the
cable. Ensure this jumper is set correctly.
36