Filter
Top Products
15
-
Com Ports Select the device to be connected on selected port.
Dome : None/Dome …
MUX : None/DUPLEX/TRIPLEX/AUX IN/AUX I/O…
DVR485 : None/ADR/SDR/IDR/AUX IN/AUX I/O…
DVR232 : None/ADR/SDR/IDR/AUX IN/AUX I/O…
Save and Exit Save the programmed data and return to the previous Menu
(Exit without saving if you press ESC key)
Note) AUX IN : auxiliary signal input ( simplex mode)
AUX I/O : when auxiliary signal input , respond to the signal (Half duplex mode)
- Set Slave kbd
Slave kbd : ON/OFF ON- Slave KBD exit, OFF- Not exist.
MUX control : ON/OFF Set accessibility of the multiplexer menu at slave keyboard
Dome Menu: ON/OFF Set accessibility of the dome camera menu at slave keyboard
Release :INF/001~200s INF (Infinite) - Slave Keyboard user never have the control right of the
dome which is selected by master Keyboard users
1 ~ 200s( Second) - After elapse of programmed time since master
Keyboard user use the dome, slave Keyboard user can get the control
right of the dome.
Save and Exit Save the programmed data and return to the previous Menu
- Exit
- Data Bank - Up/Download saved data of the dome
DataBank 1 : 001 001— Data from Dome ID 001 is exist on Bank 1
Upload If you are sure to upload or clear data to the selected dome then
Clear Data press Enter key, ESC key to cancel and exit.
DataBank 2 : Empty
DownLoad If you are sure to download data from the selected dome then
Exit Press Enter key, ESC key to cancel and exit.
- Alarm
- Alarm Check : ON/OFF Whether K/B check the alarm input of domes or not.
On : 32 domes, Off : 64 dome cameras supported.
- Alarm Beep : ON/OFF When dome’s alarm, beep sound on or off
- Exit
2.4 Maser & Slave Keyboard setting
You can use two keyboards at distant site.
Master keyboard should be setup as following procedure.
1. Check for dip switch the 7
th
of S2 “OFF”.
2. Press Ctrl + Menu. Check Slave KBD setting “ON”. (Network Set Slave Kbd Slave kbd:ON/OFF)
Slave keyboard need to setup as following procedure.
1. Check for dip switch the 7
th
of S2 “ON”.
2. If you setup all connection correctly (See Figure 4) and turn on slave keyboard, you can see
following screen.